Ants profiler not profiling wcf

[amittuteja]

Hi,

We are trying to use ANTS profiler for profiling the wcf service,but profiler stops at the point where wcf method call is made.

I want that methods within wcf service should be profiled as well.

E.g. if WCF exposes function ABC() which in turn call fucntions:
ABC1() and ABC2 ().

Then profiling should be done on ABC,ABC1() and ABC2().

I followed the steps mentioned at following link:
http://www.red-gate.com/support/Knowledgebase/ANTS_Profiler/AP4%20Profiling%20WCF%20in%20IIS.pdf

Can anyone let me know the steps on how to do so?

Regards,
Amit

[Chris.Allen]

You will get results for all method calls (except when there is a managed to unmanaged transtion, of course).

Make sure you have looked at the "method view" grid (the tiny, middle button at the bottom- above the source code view if its active)

But. we have found some occasions where some methods seem to get missed out but this is solved by using the line-level ("most detail") profiling mode.